I 'm always in need of a baby shower card so was so excited when I saw the Playing with Patterns Suite! Lots of color and patterns to make the cutest cards for any baby shower!
Project Recipe
Card Base and Cut Instructions: DSP = Designer Series Paper
Card Base: Crushed Curry - 5 1/2 x 8 1/2 scored at 4 1/4
Layer 1 - Playing with Patterns DSP - 4 1/8 x 5 3/8
Layer 2 - Playing with Patterns DSP - 3 1/2 x 4
Layer 3 - Shimmer White - 2 1/2 x 3
Layer 4 - Playing with Patterns DSP - 2 x 2
Layer 5 - Whisper White - 4 x 5 1/4
Layer 1 - Using a pencil lightly draw three lines onto sheet.
Draw the first line 1 inch from the top edge. Then 2 more lines each 1 inch below the line above it.
These will be used to line up the dies to cut out the sentiment!
Place sheet onto your die cut base and plate then line up letters and tape them in place using washi tape.
Run through the die cut machine making sure to save the centers of the D and O's.
Layer 2 - Adhere behind Layer 1 lining the back of the letters.
Glue in the center's of the D and O's.
Wrap ribbon around the bottom of Layer 1 about 1 inch from bottom edge.
Tie a bow and adhere to the strip of ribbon using a Mini glue dot on the left side.
Adhere Layer 1 onto card front.
Layer 3 - Stamp the Panda and Baby from the Wildly Happy Stamp Set in Stazon Black ink.
Color in the Panda with Basic Black Water Color pencil.
Using the Water Painters (medium tip) blend the water color pencil.
Adhere Panda to Layer 1 using stampin dimensionals to the right side of the card front.
Layer 4 - Using the 4th smallest circle die cut out a circle then cut down the middle.
Adhere half circles to the card front on either side of the words "of and joy" keeping flat edge flush with sides.
Layer 5 - Stamp sentiment onto center of sheet in Coastal Cabana ink.
Next stamp the solid hearts on either side of the sentiment One in Crushed Curry and the other one in Calypso Coral.
Stamp again in the upper right and left corners using the opposite color of the hearts below next to the sentiment.
Adhere Playing with Patterns Resin Dots to the half circles on the front as shown.