P retty card perfect for lots of occasions including a birthday or belated birthday using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Blackberry Bliss Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" of rows of tiny octagons on light purple background design from Favored Flowers 12" x 12" Designer Series Paper
- 2-3/8" x 5-1/4" from Evening Evergreen Cardstock
- 2-1/4 " x 5-1/4" of tightly packed purple roses and dark green leaves design from Favored Flowers 12" x 12" Designer Series Paper
- 1-3/4" x 3-1/4" from Fresh Freesia Cardstock
Adhere the strip of tightly packed purple roses and leaves Favored Flowers Designer Paper to the center of the Evening Evergreen rectangle. The top and bottom edges will be even.
Adhere the matted designer paper strip to the right side of the vertical light purple octagons Favored Flowers Designer Paper rectangle so there is about 3/8" of light purple designer paper showing along the right edge. The top and bottom edges will be even.
Cut a 4-1/2" piece of the Evening Evergreen 3/8" Open Weave Ribbon.
Lay the ribbon across the layered designer paper rectangle about 1-1/8" from the bottom. Fold the ends of the ribbon over and secure the ends of the ribbon in place with strips of Tear & Tape Adhesive.
Remove the protective backings from the Tear & Tape strips and add Stampin' Seal to the back of the designer paper as needed. Adhere to the front of the Blackberry Bliss card.
Mount the sentiment of choice from the Nature's Prints Set on an appropriate size block. Ink it up with the Blackberry Bliss Ink Pad. Stamp it in the center of the Fresh Freesia rectangle.
Pick out the label die from the Natural Prints Dies. Put it on top of the stamped sentiment on a platform on your Stampin' Cut & Emboss Machine so the sentiment is centered in the die. Run through the machine.
Use Stampin' Dimensionals to adhere the sentiment label to the front of the card so it is centered over the ribbon and the layered designer paper strip as shown.
Cut a 3" piece of the Evening Evergreen 3/8" Open Weave Ribbon.
Slide one end of the ribbon under the ribbon already on the card front on the left side of the sentiment label. Tie in place using a half knot. Trim the ends.
Use the mini spatula on the Take Your Pick to carefully peel up 1 large and 2 small Fresh Freesia opal rounds from the sheet of 2021-2023 In Color Opal Rounds making sure that you get the adhesive backings as well. Adhere the large opal round to the sentiment label cut out as shown. Adhere the two small ones in a vertical row on the upper left side of the card using the octagons on the designer paper pattern to help with spacing.