P retty card perfect for lots of occasions using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Night Of Navy Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" of small vanilla plants on gray background design from Sun Prints 12" x 12" Designer Series Paper, cut so the plants are vertical on the horizontal rectangle
- 3-1/8" x 4-3/8" from Night Of Navy Cardstock
- 3" x 4-1/4" from Gray Granite Cardstock
- 1-3/4" x 3-1/4" from Gray Granite Cardstock
- 2 pieces each 1-1/2" x 2-3/4" from Very Vanilla Cardstock
Adhere the piece of Sun Prints Designer Paper to the front of the Night Of Navy card. Make sure the plants are pointing up.
Insert the 3" x 4-1/4" Gray Granite rectangle into the Fern 3D Embossing Folder. Use the line printed on the front flap of the folder to make sure it is lined up straight. Place the folder with the cardstock inside on the platform on your Stampin' Cut & Emboss Machine and run through the machine.
Adhere the dry embossed Gray Granite rectangle to the center of the Night Of Navy rectangle.
Cut a 5" piece of the Night Of Navy 3/8" Bordered Ribbon.
Lay the ribbon across the bottom of the horizontal, matted, dry embossed Gray Granite rectangle so it is about 3/4" from the bottom. Fold the ends of the ribbon over and secure the ends of the ribbon in place with strips of Tear & Tape Adhesive.
Remove the protective backings from the Tear & Tape strips and add Stampin' Seal to the back of Night Of Navy rectangle. Adhere it to the front of the card in the center.
Mount the sentiment of choice from the Nature's Prints Set on Block H. Ink it up with the Night Of Navy Ink Pad. Stamp it in the center of the 1-3/4" x 3-1/4" Gray Granite rectangle.
Pick out the label die from the Natural Prints Dies. Put it on top of the stamped sentiment on a platform on your Stampin' Cut & Emboss Machine so the sentiment is centered in the die. Run through the machine.
Use the side of the brush tip of the Night Of Navy Marker to outline the edges of the label cut out.
Use Stampin' Dimensionals to adhere the outlined sentiment label cut out to the front of the card so it is centered over the ribbon on the right side. Leave a small amount of ribbon showing on the right side of the label cut out.
Mount the fern image from the Nature's Prints Set on Block C. Ink it up with the Gray Granite Ink Pad. Stamp it in the center of both Very Vanilla rectangles remembering to re-ink the stamp in between.
Pick out the matching fern die from the Natural Prints Dies. Put it on top of one of the stamped ferns on a platform on your Stampin' Cut & Emboss Machine so the fern is centered in the die. Run through the machine. Repeat with the other fern.
Adhere the fern cut outs to the front of the card as shown so they overlap each other and the ribbon on the left side of the sentiment label cut out and the bottoms of the ferns are tucked under the left side of the sentiment label cut out.
Use the mini spatula on the Take Your Pick to carefully peel up one large Starry Sky flower from a sheet of Fun Flowers Resin Shapes making sure that you get the adhesive backing as well. Adhere it to the top right corner of the dry embossed Gray Granite rectangle.
Cut a 3-1/2" piece of the Night Of Navy 3/8" Bordered Ribbon.
Slide one end of the ribbon under the ribbon on the card front on the right side of the sentiment label cut out. Tie in place with a half knot. Trim the ends.