Project Recipe
Cutting:
11 x 4 1/4 Whisper White Cardstock
4 x 2 All is Bright DSP
4 x 1/2, 4 1/4 x 1/2, 2 3/4 x 1/2 3 1/2 x 2 Copper Foil Sheet
Preparation:
Emboss the front of the card base using the Swirls and Curls TIEF.
Lay the copper strip (4 x 1/2) next to the DSP and butt together using tape on back to hold in place.
Wrap a 4 1/2 strip of copper edged white ribbon at the seam and adhere to the back.
Cut the Merry die from the larger piece of copper foil.
Cut the label from the copper foil.
Stamp & Bright in Real Red Ink being careful to push them close together to fit on the smaller label die cut. Cut the label with the die.
Stamp the inside sentiment in Real Red. Leave room to adhere the copper strip against the embossed edge.
Assembly:
Adhere the 4 1/4 strip of copper foil to the inside of the card along the edge of the embossing.
Adhere the DSP layer to the left of the card front.
Add the Merry using Fine Tip Glue Pen,
Adhere the small label to the larger copper foil label and adhere to card front using dimensionals.