P retty card perfect for lots of occasions using Stampin' Up! products.
Project Recipe
Cut cardstock, designer paper, and Adhesive Sheets pieces to the following sizes using a Paper Trimmer:
- card from Lemon Lolly Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Lost Lagoon Cardstock
- 3-3/4" x 5" of diagonal lines of yellow dots and light blue lines on white background design from Floral Delight 12" x 12" Designer Series Paper
- 2-3/4" x 4-1/4" from Lost Lagoon Cardstock
- 2-5/8" x 4-1/8" from Adhesive Sheets
- 3-3/4" x 5" from Basic White Cardstock
- 1-1/4" x 2" from Lemon Lolly Cardstock
- 1-1/8" x 1-7/8" from Adhesive Sheets
Adhere the piece of Floral Delight Designer Paper to the center of the large Lost Lagoon rectangle and then to the front of the Lemon Lolly card.
Peel the protective backing off of the larger Adhesive Sheets rectangle. Adhere the Adhesive Sheets rectangle to one side of the remaining, smaller Lost Lagoon rectangle. Be sure to leave the other protective backing in place for now.
Pick out the lattice rectangle die from the Linked Together Dies. Put it on top of the Lost Lagoon rectangle on a platform on your Stampin' Cut & Emboss Machine so the Lost Lagoon (blue) side is face up. Run through the machine. Use the paper-piercing tool on the Take Your Pick to remove the pieces.
Carefully remove the protective backing from the back of the lattice rectangle cut out. Adhere it to the center of the card front.
As you are ready to stamp using the Linked Together Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the "enjoy" sentiment from the Linked Together Set on Block C. Ink it up with the Lost Lagoon Ink Pad. Stamp it in the center of the vertical white rectangle.
Pick out the large diamond die from the Linked Together Dies. Put it on top of the sentiment stamped rectangle on a platform on your Stampin' Cut & Emboss Machine so it is centered over the sentiment and is taller rather than wider. Run through the machine.
Adhere the sentiment diamond to the card front so it is centered over the lattice rectangle as shown.
Peel the protective backing off of the smaller Adhesive Sheets rectangle. Adhere the Adhesive Sheets rectangle to one side of the Lemon Lolly rectangle. Be sure to leave the other protective backing in place for now.
Pick out the set of two connected larger flowers die from the Linked Together Dies. Put it on top of the Lemon Lolly rectangle on a platform on your Stampin' Cut & Emboss Machine so the Lemon Lolly (yellow) side is face up. Run through the machine. Use the paper-piercing tool on the Take Your Pick to remove the pieces.
One at a time, carefully remove the protective backing from the back of the flower cut outs. Adhere them to the card front as shown so they overlap the upper right side of the diamond cut out and each other a bit.
Use the mini spatula on the Take Your Pick to carefully peel up 2 small Daffodil Delight opals from a sheet of Opal Rounds Assortment making sure that you get the adhesive backings as well. Adhere them to the card front as shown so they are centered over the openings in the centers of the flower cut outs.
Cut a 10" piece of the Lost Lagoon Soft Cording.
Tie a small bow in the center of the cording. Trim the ends.
Use a Mini Glue Dot to adhere the cording bow to the lower left side of the diamond cut out on the front of the card as shown.