P retty treat bag made with Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a Paper Trimmer:
- 2" x 4" from Basic White Cardstock
- 2" x 4" from Moody Mauve Cardstock
- 1-1/2" square from Basic White Cardstock
Pick out the rounded top tag die from the Tailor Made Tags Dies that cuts out a tag that is 3-3/8" long. Put it on top of the large white rectangle on a platform on your Stampin' Cut & Emboss Machine. Run through the machine. Repeat with the Moody Mauve rectangle.
As you are ready to stamp using the Lasting Joy Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the "I'm so thankful" sentiment from the Lasting Joy Set on Block G. Ink it up with the Wild Wheat Ink Pad. Stamp it on the horizontal white tag cut out so the hole is on the left side and the sentiment is slightly above center and as close to the left side as possible.
Mount the "for you" sentiment from the Lasting Joy Set on Block A. Ink it up with the Moody Mauve Ink Pad. Stamp it on the previously stamped white tag so it is centered just below the previously stamped sentiment.
Mount the larger leaf stem image from the Lasting Joy Set on Block B. Ink it up with the Wild Wheat Ink Pad. Stamp it on the previously stamped white tag so the leaves curve under the sentiments as shown. Re-ink the stamp again and stamp it just to the right of the previously stamped leaf stem as shown.
Mount the group of three tiny leaves image from the Lasting Joy Set on Block A. Ink it up with the Wild Wheat Ink Pad. Stamp it on the previously stamped white tag so they are under the stamped sentiments in the lower left corner of the tag as shown.
Mount the single, tiny, open flower image from the Lasting Joy Set on Block A. Ink it up with the Moody Mauve Ink Pad. Stamp it on the previously stamped white tag so it is centered inside the previously stamped set of 3 tiny leaves as shown. Clean the stamp using the Stampin' Scrub and Stampin' Mist Stamp Cleaner and/or Simply Shammy, but leave it on the block.
Adhere the stamped white tag to the top of the Moody Mauve tag at a slight angle as shown. Make sure the holes on the left side of the tags line up.
Mount the large flower image from the Lasting Joy Set on Block B. Ink it up with the Moody Mauve Ink Pad. Stamp it in the center of the small white square.
Re-ink the single, tiny, open flower image on Block A with the Wild Wheat Ink Pad. Stamp it in the center of the previously stamped large flower image.
Use Paper Snips Scissors to cut out the large flower image by hand.
Use Stampin' Dimensionals to adhere the flower cut out to the tags in the upper right corner so it covers the ends of the stamped leaf stems.
Cut a 6" piece of the White 1/2" Iridescent Ribbon.
Thread the ribbon through the holes in the top of the tags and pull it through until it is even.
Cut a 4" piece of the Wild Wheat jute trim from the 2023-2025 In Color Jute Trim.
Tie the jute trime around the ribbon using a knot so it is tied just above the top of the tags. Trim the ends of the ribbon and the jute trim.
Carefully pick apart the jute trim so it is frayed. Trim again if necessary.
Fill the bag with treats. Fold the top of the bag over to the back of the bag. Use a small piece of Scotch tape or washi tape to hold the bag closed.
Adhere the tag to the front of the bag at a slight angle as shown so the folded over top of the bag is on the left side and the bag is horizontal.
Use the mini spatula on the Take Your Pick to peel up one large copper dot and one small copper dot from the sheet of Brushed Metallic Dots making sure you get the adhesive backings as well. Adhere them to the centers of the stamped flowers.