F ound this great card in the Facebook page for Demonstrators by Lisa's Stamp Studio.
Project Recipe
Fold your 8 1/2 x 5 1/2 card base in half.
Then using the paper trimmer, cut the front flap of the card at a diagonal from the upper left to the bottom right corner. Leaving you only the bottom half of the front flap.
Next, take 2 pieces of 4 x 5 1/4 pieces of DSP, place one on the "inside" of your card that is now 1/2 visible because we cut off the front flap.
Take care to cut the diagonal in the second piece so it lines up with the front of your card. Cut the DSP from corner to corner on the diagonal. Once cut you can't flip it and use the other side so pick and cut well.
Fold your 3 x 8 piece of card stock in half. Attach to the inside of your card in the center.
Using the cut-off piece from the front flap. Stamp and die-cut the collar, tie and pocket square (AKA just the tip of the other tie), and buttons if you wish.
You will also need the small rectangle to form the pocket. You will need to trim it down it is too long.
Attach the collar to the DSP with dimensionals.
Optional-Then trim the DSP in the V away for the white to show.
Add the DSP to the folded base
Add the tie, buttons, and pocket square as shown. TIP DON'T PLACE GLUE NEAR BOTTOM OF TIE!