P retty packaging using Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a Stampin' Trimmer:
- 2" x 4" from Whisper White Thick Cardstock
-1-1/4" x 2-1/2" from Tranquil Tide Cardstock
Unlock the Scalloped Tag Topper Punch. Slide the Whisper White Thick Cardstock into the punch as far as it will go. Punch.
Mount the horizontally striped lighthouse image from the High Tide Set on Block H. Ink it up with the Real Red Ink Pad. Stamp it along the left edge of the tag so the bottom and left edge of the image barely go off the sides of the tag.
Mount the vertically striped lighthouse image from the High Tide Set on Block H. Ink it up with the Real Red Ink Pad. Stamp off once on Grid Paper. Stamp it over the previously stamped lighthouse image on the tag.
Mount the large ground image from the High Tide Set on Block H. Ink it up with the Early Espresso Ink Pad. Stamp it along the bottom of the tag so the notch in the image fits around the bottom of the lighthouse image.
Mount the beam of light image from the High Tide Set on Block H. Ink it up with the Daffodil Delight Ink Pad. Stamp it on the tag so the beam appears to be coming out of the top of the lighthouse and going off to the right.
Mount the sentiment of choice from the High Tide Set on Block C. Ink it up with the Tranquil Tide Ink Pad. Stamp it on the tag so it is to the right side of the lighthouse and centered between the beam of light and the ground.
Unlock the Ticket Tear Border Punch. Slide the strip of Tranquil Tide Cardstock into the punch so it butts up against the guide at the back of the punch. Punch. Slide the punched cardstock over a little bit and line up the punched area with the silver design printed on the base of the punch. Punch again. Repeat until the entire length has been punched.
Adhere the punched Tranquil Tide strip to the bottom of the tag so the notches just show at the bottom of the tag. Trim off excess cardstock with Paper Snips as needed.
Adhere a small Gold Faceted Gem to the top of the lighthouse.
Cut a 6" piece of Whisper White Solid Baker's Twine. Double the twine over on itself. Slide the folded end into the hole at the top of the tag from the front. Pull the folded end up a bit and open it up. Stick the ends of the twine through the loop and pull it tight. Tie a knot in the ends of the twine about 1-1/2" from the top of the tag. Trim off excess twine.
Tie the tag to your package using Tranquil Tide 1/2" Finely Woven Ribbon.