or this card I wanted to show embossing done two ways. One with Dies and one with a Embossing Folder.
Card Cuts: DSP = Designer Series Paper
Card Base - Thick Basic White - 5 1/2 x 8 1/2 scored at 4 1/4
-Merry Merlot - (2) 4 1/8 x 5 3/8, 3 x 3 1/2,
-Early Espresso - 1 x 1 1/2
-Basic White - (2) 4 x 5 1/4, 2 x 10
-Rustic Harvest - 4 x 5 1/4
Instructions - Stamping:
-On one of the 2 x 10 Basic white piece stamp the following:
-Crumb Cake - Sentiment Banner & Leaf
-Merry Merlot - (2) Leaves
-On the 4 x 5 1/4 Basic White piece stamp the following:
-Crumb Cake - Sentiment top center (I used the sentiment from the Peaceful Moments Stamp set)
-Crumb Cake - Leaf in bottom right hand corner this will be the center leaf.
-Merry Merlot - (2) Leaves on each side of the crumb cake leaf in bottom right hand corner.
- Using the Fern 3D folder run the Leaf label through it with the Stamp N Cut Machine.
-Using the Rustic Pumpkin Dies cut the following:
-three curly vines (on left over Basic white piece)
-Using the embossed dies cut out a large pumpkin piece and long center pumpkin piece from the 3 x 3 1/2 Merry Merlot piece and the Pumpkin stem from the 1 x 1 1/2 Early Espresso piece.
- Adhere 4 1/8 x 5 3/8 Merry Merlot pieces one to the card front and the other to the inside of the card.
-Adhere the 4 x 5 1/4 DSP piece to the card front.
-Adhere embossed leaf label to the upper left corner of the DSP on card front.
--Glue Embossed pumpkin pieces together adding the curly vines and stem to the back side as shown. Then adhere to card front about 1 1/2" from left edge of DSP and flush to bottom edge.
-Adhere the 3 leaves to the right side of Card front placing the Crumb Cake leaf first about 1/2' from right edge and 7/8" from top edge. Then overlap the (2) Merry Merlot leaves on each side of the Crumb Cake leaf as shown.
-Using Dimensionals adhere the sentiment banner label as shown overlapping bottom edge of leaves and part of the pumpkin.
-Tie bow and adhere to top of leaf label with mini glue dot (Note: I folded my glue dot in half)
-Apply Basic Pearls as desired.
-Adhere 4 x 5 1/4 Basic White piece to inside of card!