T his card was case'd from North Shore Stamper - Ange McKay
Project Recipe
Card Stock
Whisper White - 8 1/2 x 5 1/5
Score @ 4 1/4
Mossy Meadow - 4 x 5 1/4
Magnolia Lane DSP - 3 pieces - 1/4 x 5 1/8
Whisper White - Scrap piece (at least 2 1/2" square) for 2 3/8" circle
Petal Pink - Scrap piece (at least 2 3/4" square) for 2 1/2" Scallop
Magnolia Lane DSP - Decide which way you want your patterns to go (2 will be one side of the DSP, the other will be the reverse side)
Layer one strip of DSP on the Mossy Meadow panel, starting at the far left. Add a 2nd strip of DSP to the far right. These two panels should show the same pattern. Then layer the last strip in the middle, making sure that it is showing the opposite panel.
Take one of the 6" pieces of Petal Pink ribbon and wrap it around the Mossy Meadow card base and tape the ends to the back of the panel. Take the 2nd 6" piece and slip it under the piece you just adhered and tie a knot to the left side. Trim off the ends.
Use Dimensionals to adhere that panel to the Whisper White card base.
On the Whisper White circle, stamp the sentiment near the top of the circle using Early Espresso.
Stamp the flower using Memento ink below and to the right of the sentiment.
Using the Petal Pink and Mossy Meadow Blends, color the flower. I started with the darker shade of Petal Pink and just colored a little at the base of each of the petals, then used the lighter shade and added a little color just above the darker shade, blending as I went. You don't want to color the whole petal.
Use that same process for the leaves, using the darker color at the base of the leaves and the lighter shade to fill in the rest and blend them together.
Using dimensionals, layer the white circle on to the Petal Pink scallop circle. Using dimensionals again, layer that on to the bottom right of the DSP layer.
Add 3 rhinestones around the Magnolia.
You are done! Now admire your beautiful card :)