F un, masculine card using Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a cutting and scoring tool:
- card from Granny Apple Green Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Pretty Peacock Cardstock
- 3-1/8" x 4-3/8" from Granny Apple Green Cardstock
- 3" x 4-1/4" from Whisper White Cardstock
- 3-1/4" x 3-3/4" from Smoky Slate Cardstock
- 1-3/4" x 3-1/2" from Granny Apple Green Cardstock
Pick out the large group of gears die from the Garage Gears Dies. Put the die on top of the Smoky Slate rectangle on a platform on your cutting and embossing tool. Run through the tool. Use the Take Your Pick Die Brush Tip and/or paper-piercing tool on the Take Your Pick to remove the pieces.
Mount the grease stain image from the Geared Up Garage Set on Block C. Ink it up with the Smoky Slate Ink Pad. Stamp it randomly onto the gears cut out. Re-ink the stamp every so often. Let the image go off the edges and let it overlap itself sometimes. Leave the stamp on the block.
Re-ink the grease stain image with the Smoky Slate Ink Pad. Stamp it in the lower right corner of the white rectangle so the image goes off the bottom edge.
WITHOUT ADHERING, place the stamped gears cut out on the left side of the stamped white rectangle.
Mount the “All Geared Up to Celebrate” sentiment from the Geared Up Garage Set on Block G. Ink it up with the Pretty Peacock Ink Pad. Stamp it in the upper right corner of the stamped white rectangle so it is about ½” from the top.
Adhere the gears cut out to the left side of the stamped white rectangle using either Fine-Tip Glue, Multipurpose Liquid Glue, or SNAIL. Trim off excess using Paper Snips.
Adhere the stamped white rectangle with gears attached to the large Granny Apple Green rectangle.
Adhere the matted white rectangle to the center of the Pretty Peacock rectangle and then to the front of the Granny Apple Green card.
Mount the car image from the Geared Up Garage Set on Block H. Ink it up with the Pretty Peacock Ink Pad. Stamp it in the center of the small Granny Apple Green rectangle.
Pick out the car die from the Garage Gears Dies. Put it on top of the stamped car image on a platform on your cutting and embossing tool so the car image is centered. Run through the tool.
Use Stampin' Dimensionals to adhere the car cut out to the card front so it is about 1” from the bottom edge and overlaps the gears on the lower right side a bit.