B right, cheery card to say hello using sneak peek products from Stampin' Up!
Project Recipe
Cut card stock and designer series paper pieces to the following sizes using a Stampin' Trimmer:
- card from Lemon Lime Twist Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Bermuda Bay Cardstock
- 1-1/4" x 5-1/4" from Very Vanilla Cardstock
- 1" x 5-1/4" of tiny vanilla diamonds on bright green background design from Eastern Palace Specialty Designer Series Paper
- 3" square from Lemon Lime Twist Cardstock
- scrap of Bermuda Bay Cardstock at least 1-1/2" wide
- scrap of Very Vanilla Cardstock at least 1-3/4" wide
Place the large Bermuda Bay rectangle into the Sparkle Embossing Folder so one long edge of the cardstock sticks out of the folder by about 1-1/4". Place the folder with the card stock inside on top of a Cutting Pad on your Big Shot Platform at the lowest possible setting. Make sure nothing is sticking off the edge of the platform. Place another Cutting Pad on top of the folder and run through the Big Shot.
Mount the solid starburst image from the Eastern Beauty Photopolymer Stamp Set on Block A. Ink it up with the Lemon Lime Twist Ink Pad. Stamp it on one end of the long vanilla strip about 1/4" from the top. Let the image go off the edge a bit. Leave the stamp on the block.
Reink the starburst image and stamp it again so that one side point of this image almost touches the side point of the previously stamped image. Repeat all the way across the vanilla strip remembering to reink the stamp each time.
Adhere the stamped vanilla strip to the strip of Eastern Palace Specialty Designer Series Paper so that about 1/4" of the designer paper shows along the top of the vanilla strip.
Adhere the stamped vanilla/designer paper strip to the dry embossed Bermuda Bay rectangle about 3/4" from the top edge.
Carefully peel up one of the long, skinny Eastern Gold Vinyl Stickers and adhere it to the Bermuda Bay rectangle just above the designer paper strip. Trim off excess sticker on each side.
Cut a 6-1/2" piece of Gold 1/4" Natural Trim.
Lay the ribbon piece across the card front so it hides the seam between the stamped vanilla strip and the Bermuda Bay Cardstock. Flip the card front over and fold the ends of the ribbon over. Adhere them in place with pieces of Tear & Tape Adhesive across the ends.
Remove the protective backings from the Tear & Tape and add more SNAIL Adhesive to the back of the Bermuda Bay rectangle. Adhere to the front of the Lemon Lime Twist card.
Pick out the large circle of flower petals thinlit and the open circle thinlit that cuts out a circle of diamonds and half circles from the Eastern Medallion Thinlits. Place the square of Lemon Lime Twist Cardstock on the Precision Plate on top of your Platform on your Big Shot. Place the flower petals circle thinlit on top in the center. Place the circle thinlit inside the center of the other thinlit and get it centered. Place a Cutting Pad on top and run through the Big Shot a couple of times. Use the Die Brush to remove the card stock if needed.
Use Paper Snips to carefully cut the flower image free from the cardstock by snipping the cardstock at the base of each valley between the flower petals.
Unlock the 1-1/4" Circle Punch. Slide the scrap of Bermuda Bay Cardstock into the punch and punch.
Adhere the Bermuda Bay circle to the center of the Lemon Lime Twist flower cut out.
Put Stampin' Dimensionals on the back of the cut out so they are hidden by the center circle. Remove the protective backings and adhere the Lemon Lime Twist flower to the left side of the card front so it is centered over the stamped vanilla strip.
Mount one of the tiny sentiments from the Eastern Beauty Set on Block A. Ink it up with the Bermuda Bay Ink Pad. Stamp it in the center of the scrap of vanilla cardstock.
Mount the "s" scroll image from the Eastern Beauty Set on Block A. Ink it up with the Lemon Lime Twist Ink Pad and stamp it right below the sentiment so it is centered and the "s" is sideways. Get as close to the sentiment as you can.
Unlock the 1" Circle Punch. Hold the punch upside down so you can see the punching area. Slide the stamped sentiment into the punch and get it centered in the punching area. Punch.
Adhere the sentiment circle to the center of the Bermuda Bay circle in the center of the Lemon Lime Twist flower cut out.
Cut a 3-1/2" piece of Gold 1/4" Natural Trim. Slide one end under the ribbon already on the card. Tie in a half knot so it is centered on the ribbon showing to the right of the flower cut out. Trim the ends.