N ice note card using Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a Stampin' Trimmer:
- card from Lemon Lime Twist Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Bermuda Bay Cardstock
- 2-3/4" x 3-1/2" from Lemon Lime Twist Cardstock
- scrap of Lemon Lime Twist Cardstock at least 3" long
Insert the Bermuda Bay rectangle into the Seaside Embossing Folder so the wavy lines will be horizontal when the cardstock is in landscape position (horizontal). Place the folder with the card stock inside on a Cutting Pad on the Big Shot Platform at the lowest possible setting. Place a Cutting Pad on top of the folder and run through the Big Shot.
Adhere the dry embossed Bermuda Bay rectangle to the front of the Lemon Lime Twist card.
As you are ready to stamp using the Dragonfly Dreams Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the complete dragonfly image from the Dragonfly Dreams Set on Block E. Ink it up with the Tranquil Tide Ink Pad. Stamp it in the center of the Lemon Lime Twist rectangle.
Pick out the open dragonfly die from the Detailed Dragonfly Dies. Place the stamped dragonfly image on the Cutting Pad on the Magnetic Platform on the Big Shot. Place the dragonfly die on top so it is centered over the image. Place another Cutting Pad on top and run through the Big Shot.
Use the Clear Wink of Stella Glitter Brush to paint some shimmer onto the wings, thorax, and eyes of the dragonfly cut out. This may cause the ink to run a bit, that's okay!
Use Stampin' Dimensionals and Mini Stampin' Dimensionals to adhere the shimmery dragonfly cut out to the front of the card on the right side.
Mount the sentiment of choice from the Itty Bitty Greetings Set on Block G. Ink it up with the Bermuda Bay Ink Pad. Stamp it in the center of the scrap of Lemon Lime Twist Cardstock.
Unlock the Classic Label Punch. Holding the punch upside down so you can see the punching area, slide the stamped sentiment into the punch and get it centered in the punching area. Punch.
Cut a 5-1/2" piece of Whisper White 3/8" Classic Weave Ribbon.
Use a strip of Tear & Tape Adhesive on the back of the sentiment label punch out to adhere it to the center of the ribbon.
On one side, fold the ribbon into 2 pleats just past the end of the label punch out. Use Mini Glue Dots to hold the pleats in place. Trim the end at a sharp angle. Repeat with the ribbon on the other side of the label punch out.
Put a strip of Tear & Tape Adhesive across the bottom of the dragonfly tail. Remove the protective backing and adhere the label punch out with pleated ribbon attached so it is centered under the dragonfly.
Use the mini spatula on the Take Your Pick to carefully peel up 5 Tranquil Tide pearls from a sheet of Share What You Love Artisan Pearls making sure that you get the adhesive backings as well. Adhere two of the pearls to either end of the sentiment label punch out and adhere the remaining three pearls randomly to the card front.