A little bit of ROARsome is what's needed!
Project Recipe
Cut Pool Party A4 cardstock to 10.5cm by 29.7cm and score at 14.8cm to make Tent-Fold card blank - BUT we are using it on it's side!
Cut Whisper White A4 to...
14.8cm x 8.2cm - front mat
9cm x 13.3cm - insert
also punch a 2" circle from W White and stamp this with your desired sentiment in Basic Gray Ink.
Cut the DSP...
'Pink Dino' = 14.8cm wide x 7.6 tall
'triangle border' = 2.4cm wide (use pattern to line up) x 10.5cm tall
Fussy cut a selection of dinos.
(you can also use the 'partial/off the edge' dinos if you place them accordingly on your cardfront)
Punch an Old Olive Starburst.
Lay a 'zigzag' of denim ribbon across the starburst, anchor with tape/snail.
Place dimensionals on the back of the sentiment circle, top and bottom. Adhere on top of ribbon/starburst, ensure 'spikes' of starburst can be seen around the entire edge.
Layer up the 'pink dino' DSP on top of the W.White front panel. Glue this onto the card front (hinge on left) about 1/2 cm down from the top edge.
Now glue on the 'border' strip about 2cm in from the left edge, this should reach the top and bottom edges of the card front.
Glue on the sentiment starburst, about 2 cm down from top edge - laying central over the border strip.
Add some enamel embellishments.
Place the fussy cut dinos, lay some flat and some on dimensionals. My tip is to shape the pterodactyl wings and only glue the body, to give the 'flying' effect.
Stamp the insert panel if desired, and once dry, glue in place.
-x-