Corner Closure Card - Magnolia Mood

{ tams # 88500 }

Print Recipe

Measurements:
Card base 10.5cm x 29.7cm (4 1/8” x 11 3/4”)
Scored at 14.9cm and cut off 7.4cm from one end.

Two pieces of card stock embossed or DSP 6.9cm x 10cm (2/4” x 4”)

One piece card stock 5.5cm x 5.5cm (2 1/4” x 2 1/4”) cut in half diagonally.

One piece of card stock embossed or DSP 5cm x 5cm (2” x 2”) cut in half diagonally.

Card insert piece 14.4cm x 10cm (5 3/4” x 4”)

Dry emboss the 2 pieces of Basic White card stock measuring 6.9cm x 10cm using the Distressed Tile 3D embossing folder.

Dry emboss the triangle piece of Basic White card stock with the Distressed Tile 3D embossing folder.

Attach the embossed panels to the card base front flap and to the 7.4cm piece of Bubble Gum Card stock and also to the triangle piece of Bubble Gum card stock.

You could also use Designer Series Paper instead of embossed card stock if you wanted to.

Stamp your sentiment on the card insert panel and the small magnolia and colour with water colour pencils or Stampin' Blends. Attach the insert to the card base.

Using small dimensionals put the dimensionals to the corner edges of the triangle and line up with the card base edge and attach to card base. (this corner piece can go on either corner, depending on where you stamp your sentiment).

Attach the embossed panel on Bubble Gum card stock to the card base, making sure it is centred and can tuck under the corner triangle.

Stamp the large Magnolia image on to Basic White card stock using Basic Gray ink.

Die cut the stamped image out.

Colour using water colour pencils, blender pen

Attached die cut stamped image to the centre panel using dimensionals.

Add some Glossy dots or embellishment of choice and a Silver/White sheer ribbon bow to finish off your card.