P retty card and matching decorated gift bag made with Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Moody Mauve Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Petal Pink Cardstock
- 3-7/8" x 5-1/8" from Basic White Cardstock
- 1-1/2" x 3-7/8" of white dots on Petal Pink background design from Subtles 6" x 6" Designer Series Paper
- 3" x 6-1/2" from Petal Pink Cardstock
- 2-1/4" x 3-1/4" from Moody Mauve Cardstock
Insert the basic white rectangle into the dotted embossing folder from the Basics 3D Embossing Folders set so about 1-1/2" of the vertical rectangle hangs out the bottom of the embossing folder. Place the folder with the cardstock inside on the platform on your Stampin' Cut & Emboss Machine and run through the machine.
Adhere the strip of Petal Pink dotted Subtles Designer Paper to the bottom of the dry embossed white card so about 1/8" of white shows along the bottom edge.
As you are ready to stamp using the Circle Sayings Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the "sending you a" banner image from the Circle Sayings Set on Block D. Ink it up with the Moody Mauve Ink Pad. Stamp the image on one end of the horizontal Petal Pink 3" x 6-1/2" strip fairly near the top leaving room to punch it out.
Unlock the 2-3/8" Circle Punch. Hold the punch upside down so you can see the punching area. Slide the stamped "sending you a" banner into the punch and get it centered in the punching area near the top edge. Punch. Leave the punch unlocked. Keep all pieces of cardstock.
Mount the "smile" sentiment from the Circle Sayings Set on Block B. Ink it up with the Moody Mauve Ink Pad. Stamp it just below the stamped banner as shown so it is centered under the banner.
Use Paper Snips Scissors to cut the sentiment stamped circle roughly in half just below the "smile" sentiment.
Adhere the half circle sentiment punch out to the white/designer paper rectangle so the bottom of the half circle is tucked behind the top of the designer paper on the left side as shown.
Adhere the dry embossed white rectangle with designer paper and sentiment half circle attached to the center of the 4" x 5-1/4" Petal Pink rectangle.
Cut a 4-3/4" piece of the Petal Pink ribbon from the Ribbon Duo Combo Pack.
Lay the ribbon across the layered cardstock/designer paper rectangle so it covers the bottom of the sentiment half-circle punch out and the seam between the white cardstock and designer paper. Fold the ends of the ribbon over and secure the ribbon in place on the back with strips of Tear & Tape Adhesive.
Remove the protective backings from the Tear & Tape pieces and add Stampin' Seal to the back of the Petal Pink rectangle. Adhere the rectangle to the front of the Moody Mauve card.
Cut a 3" piece of the Petal Pink ribbon from the Ribbon Duo Combo Pack.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon to the center of the ribbon already on the card front at a slight angle on the left side as shown.
Use the mini spatula on the Take Your Pick to carefully peel up a medium Moody Mauve dot from the sheet of 2023-2025 In Color Dots making sure that you get the adhesive backing as well. Adhere it to the front of the card as shown in the upper right corner.
Fill a Moody Mauve bag from the 2023-2025 In Color Treat Bags with treats.
Fold the top of the treat bag over towards the back. Seal closed with a small piece of Scotch tape in the center.
Pick out the largest, bumpy-topped tag die and the small, solid, three-bumps with flowers and leaves die from the Something Fancy Dies. Put the tag die on top of the Moody Mauve rectangle on a platform on your Stampin' Cut & Emboss Machine. Put the small solid die inside the bumpy top of the tag die. Make sure the dies do NOT overlap. Run through the machine. Use the Take Your Pick to remove the pieces as needed
Mount the flower arch image from the Circle Sayings Set on Block D. Ink it up with the Moody Mauve Ink Pad. Stamp the image on the other end of the 3" x 6-1/2" Petal Pink strip leaving room to punch it out.
Hold the unlocked punch upside down so you can see the punching area. Slide the stamped flower arch image into the punch and get it centered in the punching area near an edge. Punch.
Mount the "thank you" sentiment from the Circle Sayings Set on Block B. Ink it up with the Moody Mauve Ink Pad. Stamp it in the center of the circle punch out just to the right of the flower arch.
Adhere the stamped circle punch out to the center of the tag cut out as shown.
Adhere the layered tag to the front of the bag in the upper left corner at a slight angle as shown.
Cut a 12" piece of the Moody Mauve jute from the 2023-2025 In Color Jute Trim.
Tie a bow in the center of the jute. Trim the ends.
Use a Mini Glue Dot to adhere the jute bow to the front of the bag as shown at a slight angle on the lower right side of the circle punch out.
Use the mini spatula on the Take Your Pick to carefully peel up a medium and a large Moody Mauve dot from the sheet of 2023-2025 In Color Dots making sure that you get the adhesive backings as well. Adhere the medium dot to the center of the largest flower in the center of the stamped flower arch. Adhere the large dot to the lower right corner of the front of the bag as shown.