P retty gift card using Stampin' Up! products.
Project Recipe
Cut cardstock, foil sheets, and designer paper pieces to the following sizes using a Paper Trimmer and Paper Snips:
- card from Whisper White Thick Cardstock at 3" x 6" and scored at 3"
- 2-7/8" square of of dark green filigree on lighter green background design from Christmastime Is Here Specialty Designer Series Paper
- large rose and leaves hand cut from large bouquet on spotted gold white background design from Christmastime Is Here Specialty Designer Series Paper
- 2 small roses hand cut from large bouquet on spotted gold white background design from Christmastime Is Here Specialty Designer Series Paper
- scrap of Whisper White Cardstock at least 3-1/2" long
- scrap of Gold Foil Sheets at least 3-1/2" long
Adhere the square of Christmastime Is Here Specialty Designer Series Paper to the front of the 3x3" Whisper White Thick gift card.
If you haven't already done so, use Paper Snips to cut out a large rose with leaves and 2 small roses from a sheet of Christmastime Is Here Specialty Designer Series Paper.
Use SNAIL to adhere the large rose with leaves cut out to the center of the front of the card.
Use SNAIL to adhere one of the small rose cut outs to the front of the card so it is tucked under the upper left side of the big rose a bit.
As you are ready to stamp using the Christmas Rose Photopolymer Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the "May this Christmas..." sentiment from the Christmas Rose Photopolymer Set on Block B. Ink up ONLY the words "warmth & love" using the brush tip of the Cherry Cobbler Marker. Stamp it in the center of the strip of white cardstock.
Unlock the Classic Label Punch. Holding the punch upside down so you can see the punching area, slide the stamped sentiment into the punch and get it centered in the punching area. Punch. Leave the punch unlocked.
Slide the strip of Gold Foil Sheets into the unlocked Classic Label Punch. Punch.
Cut the gold foil punch out in half vertically.
Use small pieces of Tear & Tape Adhesive to adhere the cut pieces of gold foil punch out to the back of the sentiment punch out so the foil peeks out on either side about 1/8".
Use Tear & Tape Adhesive to adhere the layered sentiment punch out to the front of the card so it overlaps the bottom of the large rose cut out a bit.
Use Mini Stampin' Dimensionals to adhere the remaining small rose cut out to the front of the card so it overlaps the upper right side of the sentiment punch out and the lower right side of the large rose cut out a little bit.
Use the mini spatula on the Take Your Pick tool to pick up 3 different sized dots from a sheet of Gold Glitter Enamel Dots being sure to get the adhesives as well. Adhere them randomly to the card front.