F
ound this on Facebook from SU!
https://www.facebook.com/notes/stampin-up/needlepoint-spool-cards/10157090334282512/
Project Recipe
Take the 11 x 4 1/4 piece of paper and fold in half. Then punch top/bottom both side at 1 3/8 on the envelope punch board. Trim the middle between the punches on the paper trimmer. To make it look like a spool. Then punch the wood DSP at 1 3/8 on all sides also.
Pick you DSP and cut a 4 x 2 1/2 tall strip. Your width will depend on how wide your wood paper is so you will have to trim to fit.
Punch Ribbon Border and attach to DSP. You can now attach to wood DSP. Then attach Wood DSP to card base.
Stamp and punch flowers and leaves. Add to card. I used Dimensionals for the flower.
Choose and stamp your words and add to the card.