F un tag perfect for celebrating lots of occasions using Stampin' Up! products.
Project Recipe
Cut cardstock and Adhesive Sheets pieces to the following sizes using a Paper Trimmer:
- 2" x 4" from Pacific Point Cardstock
- 2-1/2" square from Melon Mambo Cardstock
- 1-1/2" square from Mango Melody Cardstock
- 1/2" x 2-1/4" from Pool Party Cardstock
- 3/8" x 2-1/4" from Calypso Coral Cardstock
- 1-1/2" x 2-1/4" from Mango Melody Cardstock
- 1-3/8" x 2-1/8" from Adhesive Sheets
Unlock the Scalloped Tag Topper Punch. Slide one short edge of the Pacific Point strip into the punch as far as it will go. Punch.
Pick out the stitched edge heart die that dry embosses stitching on a heart that is 1-3/4" wide and the scalloped edge, stitched heart die that is 2-1/4" wide from the Stitched Be Mine Dies. Put the larger die on top of the Melon Mambo square on a platform on your Stampin' Cut & Emboss Machine. Place the smaller heart die inside the larger one so it is centered. Run through the machine. Use the Take Your Pick Die Brush Tip and Take Your Pick to remove the pieces. Keep the solid, stitched heart cut out. Make sure you remove the thin, scalloped, outline heart from the larger die or it won't work properly the next time you try to use it.
Adhere the Melon Mambo stitched heart cut out to the top of the Pacific Point tag.
Pick out the scalloped edge, stitched heart die that is 1-1/16" wide from the Stitched Be Mine Dies. Put the die on top of the Mango Melody square on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.
Use a Stampin' Dimensional to adhere the Mango Melody heart cut out to the center of the Melon Mambo heart on the tag.
Use the Fine-Tip Glue Pen or Multipurpose Liquid Glue to adhere the strip of Calypso Coral Cardstock to the bottom of the tag just below the bottom of the Melon Mambo heart.
Use the Fine-Tip Glue Pen or Multipurpose Liquid Glue to adhere the strip of Pool Party Cardstock to the bottom of the tag so it is just below the other strip and a small bit of blue shows between the strips.
Use Paper Snips to trim off excess cardstock on the right and left edges of the tag.
Peel the protective backing off of the Adhesive Sheets rectangle. Adhere the Adhesive Sheets rectangle to one side of the Mango Melody rectangle. Be sure to leave the other protective backing in place for now.
Pick out the script word "Happy" die from the Word Wishes Dies. Put it on top of the Mango Melody rectangle on a platform on your Stampin' Cut & Emboss Machine so the Mango Melody side is facing up. Run through the machine. Use the Take Your Pick Die Brush Tip and Take Your Pick to remove the pieces. Make sure the protective backing for the Adhesive Sheet stays in place for now.
Carefully remove the protective backing from the back of the word "Happy" cut out and adhere it to the bottom of the tag at a slight angle so it overlaps the Calypso Coral and Pool Party strips.
Cut a 10" piece of the Pool Party 3/8" Sheer Ribbon.
Slide the tag onto the ribbon and get it centered. Holding the loose ends of the ribbon together, loop them around and tie a half knot in the top. Trim the ends.