Project Recipe
Fold 4-1/4" x 11" Basic Black cardstock in half for card base.
Drag Flirty Flamingo ink across 4-1/4" x 3-3/4" Flirty Flamingo cardstock.
Adhere layer to card front with Stampin' Seal.
Adhere 3" x 4" DSP to card front with Stampin' Seal.
Die-cut center of 3-3/4" x 5" Basic Black cardstock with 2nd largest die from Layering Ovals dies.
Add texture to layer with Brick & Mortar 3D embossing folder.
Apply Craft White ink randomly over embossed surface with Stamping Sponge.
Adhere layer to card front with dimensionals.
Fussy cut cat out of DSP.
Adhere to card front with dimensionals. Tip: I double stacked the dimensionals behind the areas of the image that is over the die-cut opening so the image would lay level.
Fussy cut mouse out of DSP.
Adhere to card front with liquid glue.
Stamp sentiment on scrap of Real Red cardstock with Versamark ink using a masking technique.
Masking Technique Tip: I set my sentiment up on my stamparatus and stamped the image on a sticky note. I then cut the sticky note into two pieces (where I wanted to separate the sentiment). When stamping each portion of the sentiment, I placed the sticky note on my cardstock to cover (mask) the portion of the stamp I did not want.
Heat emboss with White powder.
Cut out with Classic Label punch.
Adhere to card front with dimensionals.
Drag Flirty Flamingo ink across 4-1/4" x 3-3/4" Flirty Flamingo cardstock.
Adhere layer to card inside with Stampin' Seal.
Stamp sentiment on 3-3/4" x 5" Whisper White cardstock with Real Red ink using a masking technique.
Stamp mouse with Memento ink. Color with Real Red and Flirty Flamingo markers.
Adhere layer to card inside with Stampin' Seal.
Hope you enjoy!